Where has most builders ran the electric wires from the rear and wings of your plane forward and then up to the panel?
I am building the RV7A and in the process of running the wiring. I think that I could run the wires from the center of the Spar forward on the floor under the Boost pump to the firewall up then forward to the panel.
Thanks
Dave
Electric Chase
That is pretty much my plan. I don't want to have any visible wires in the cabin, so everything is going to go down the center tunnel.
Bruce Hill
RV-9A N5771H flying over 1100 hours!
Build Log at http://www.overthehills.com/RV-9A-Project
Blog at https://flyingoverthehills.wordpress.com/
EAA Tech Counselor, A&P
RV-9A N5771H flying over 1100 hours!
Build Log at http://www.overthehills.com/RV-9A-Project
Blog at https://flyingoverthehills.wordpress.com/
EAA Tech Counselor, A&P
+1 for me. Ran all my wires under the electric fuel pump.
Mike Bullock
http://www.rvplane.com
RV-7 | Superior IO-360 | Whirlwind 200RV
Garmin GTN650 | GRT Dual Sport SX EFIS
Status: FLYING!
http://www.rvplane.com
RV-7 | Superior IO-360 | Whirlwind 200RV
Garmin GTN650 | GRT Dual Sport SX EFIS
Status: FLYING!