| View previous topic :: View next topic |
| Author |
Message |
RVNewsletter Class E

Joined: 29 Mar 2006 Posts: 249 Location (Optional): St. Paul, MN.
|
Posted: Fri May 30, 2008 11:44 pm Post subject: Nose gear bolt access hole in firewall |
|
|
Hmmm... I thought I posted this question earlier and now I can't find it. Never got a response from Van's on it.
DWG 46A calls out a 1" hole in the firewall for access to the nose gear bolt and refers to DWG 19 for specifics. DWG 19, however, calls for a 3/4" hole.
Has anyone ever gotten the OFFICIAL word from Van's on which of the two is the correct instruction? |
|
| Back to top |
|
 |
weezbad Class C
Joined: 21 Oct 2007 Posts: 528 Location (Optional): darlington s.c.
|
Posted: Sat May 31, 2008 8:52 am Post subject: |
|
|
i have enlarged mine to 1 inch..if i was doing it again i would move the center location up a touch. maybe an 1/8. the bolt goes in a such a steep angle that mine caught the top going in. YMMV _________________ william....don't let it beat you down, you are stronger than you think. |
|
| Back to top |
|
 |
|