Strobe wing root connection question

A place to discuss the design & installation of electrical systems.
Post Reply
User avatar
RVNewsletter
Class D
Posts: 259
Joined: Wed Mar 29, 2006 9:57 am
Location: St. Paul, MN.
Contact:

Strobe wing root connection question

Post by RVNewsletter »

Let's say I want to run the three-wire shielded power cable from my Whelen power supply out to the wing -- which, of course, I do. Originally I was going to just coil up 15 feet of wire on the fuse until the wings are on and then run it out, connect it up and be done. But now I'm hearing that experimentals may no longer be allowed to make first flights at my home airport so when it comes time, I may have to take the wings off, cut the wires and reassemble at another airport. A true PITA.

So I figure I'll just make a wing root connection. My question: What do I do with the drain wire at that connection?

User avatar
Wicked Stick
Class B
Posts: 1000
Joined: Wed Feb 09, 2005 10:00 pm
Location: KEWB

Post by Wicked Stick »

Do you have conduit running inside the wings ?
If so, just disconnect the wire at the tips and pull them back through the conduit and re-coil at the fuse.
Dave "WS" Rogers
RV-8 (125 hrs & counting)
N173DR

User avatar
jim_geo
Class C
Posts: 843
Joined: Fri Nov 12, 2004 9:58 pm
Location: KCVO

Post by jim_geo »

You should be able to get a one time variance for the first flight in order to get it to a more suitable location. Run that wire! Damn the torpedoes full speed ahead.

Post Reply