#10 screw dimple die that's pullable?

tmbg · Post by **tmbg** » Mon Sep 19, 2011 8:39 am

I realized that I failed to drill and dimple the screw holes in my aft skins that hold my rudder cable exit chafe tube adel clamps. Now that the structure is complete, I'm not sure how to go about doing that.

Is anyone aware of a die similar to a pop-rivet no access dimple die, but for a #10 screw?

Or, anyone have other suggestions on a reasonable way to dimple that?

tmbg · Post by **tmbg** » Mon Sep 19, 2011 8:42 am

I guess I could have looked a little harder first:

http://www.averytools.com/prodinfo.asp?number=1027

disregard