Drilling stainless firewall *HELP*

A place to discuss workshops and the use and desirability of tools.
Post Reply
Havithuvi
Class G
Posts: 1
Joined: Mon Dec 24, 2018 4:52 am
Location: Clifton, NJ

Drilling stainless firewall *HELP*

Post by Havithuvi »

Hi Everyone,

I am having a hard time getting my firewall match drilled. I am using Avery cobalt #40 drill bits with "off the shelf" Home Depot cutting oil. Further, I'm using my cordless drill on very low speed with quite a bit of pressure. After monkeying with this for well over an hour, I have one hole and about 6-7 trashed drill bits.

My question for those who have already completed this step.....

Exactly what brand, type of drill bit did you use?
Exactly what type of cutting oil did you use?

Any help on this would be fantastic!

Thanks!

User avatar
bullojm1
Chief Rivet Banger
Posts: 1357
Joined: Sat Mar 25, 2006 6:37 pm
Location: KDMW
Contact:

Re: Drilling stainless firewall *HELP*

Post by bullojm1 »

What sort of drill are you using? I don't recall anything special about drilling SS.....my drill bits are from Avery, and I used BoeLube , however, any cutting oil should work? My thought is you might be turning the drill bit too fast. A slower speed drill with light pressure applied to the bit (let the bit due the cutting!) might be a solution for you.
Mike Bullock
http://www.rvplane.com
RV-7 | Superior IO-360 | Whirlwind 200RV
Garmin GTN650 | GRT Dual Sport SX EFIS
Status: FLYING!

User avatar
captain_john
Sparky
Posts: 5880
Joined: Sun Oct 31, 2004 9:17 am
Location: KPYM

Re: Drilling stainless firewall *HELP*

Post by captain_john »

Like Mike said, speed and feed are both the key. You need to find that sweet spot. Boelube works great, but also try Parpolive gold dishwashing liquid as a lubricant. A friend of mine who is a plumber taught me that trick. Plumbers drill stainless steel sinks all the time. Using a unibit works very well also. Try one of those.

Hole punches work very well also. If you have large holes like the one for the heater or wire pass-throughs a Greenlee hole punch is going to be on your wishlist. You will know when you are done working with stainless because the bleeding stops! LOL good luck!

:mrgreen: CJ
RV-7
Garmin G3X with VP-X & a TMX-IO-360 with G3i
It's all over but the flying! 800+ hours in only 3 years!

User avatar
sibriggs
Class G
Posts: 27
Joined: Sun Nov 22, 2015 9:31 pm
Location: KCON

Re: Drilling stainless firewall *HELP*

Post by sibriggs »

Slow the speed down. Drill at a very slow RPM. Too fast and it won't cut.
AP-IA - ATP,CFII,Multi,SES,Gliders

Built a Vari-Eze in the 80's, now RV9

Post Reply