I have used this jig to drill the joint plate between the leading edge and fual tank for the RV-7A wing.
platenut jig (shop made)
-
Philip Cobbin
- Class G
- Posts: 25
- Joined: Fri Nov 12, 2004 8:23 am
- Location: Arizona
- Contact:
platenut jig (shop made)
Here is an example of a home made platenut jig made from 1/4 inch bar stock.
I have used this jig to drill the joint plate between the leading edge and fual tank for the RV-7A wing.
I have used this jig to drill the joint plate between the leading edge and fual tank for the RV-7A wing.