A place to discuss workshops and the use and desirability of tools.
-
jim_geo
- Class C
- Posts: 843
- Joined: Fri Nov 12, 2004 9:58 pm
- Location: KCVO
Post
by jim_geo »
I wanted a simple way to get at those four rivet holes on the leading edge of the emp.
While wandering around my shop I found a bar of Aluminum, drilled a hole in the end of it and wala a dimple die holder.
It works very well.
-
captain_john
- Sparky
- Posts: 5880
- Joined: Sun Oct 31, 2004 9:17 am
- Location: KPYM
Post
by captain_john »
Nice rig! Good tip!
I did a similar thing with a small slab of steel bar, but I drilled and countersunk the bar itself.
CJ
RV-7
Garmin G3X with VP-X & a TMX-IO-360 with G3i
It's all over but the flying! 800+ hours in only 3 years!
-
Guest
Post
by Guest »
Check out the free upgrade on a DRDT-2 Dimpler at
www.planetools.com as this unit does consistent and professional quality dimples.
-
captain_john
- Sparky
- Posts: 5880
- Joined: Sun Oct 31, 2004 9:17 am
- Location: KPYM
Post
by captain_john »
Ummmm, what FREE UPGRADE is that???
CJ
RV-7
Garmin G3X with VP-X & a TMX-IO-360 with G3i
It's all over but the flying! 800+ hours in only 3 years!
-
bmurrish
- Class D
- Posts: 482
- Joined: Thu Jan 06, 2005 11:42 am
- Location: Colorado Springs
Post
by bmurrish »
Hey CJ,
A little late for you. You get a free upgrade to the DRDT-2 when you buy their RV tool kit.
Bill Murrish
RV-8 Fuselage
-
cjensen
- Whiskey Victor
- Posts: 5275
- Joined: Sat Apr 23, 2005 10:36 pm
- Location: Green Bay, WI
Post
by cjensen »
too late for me to, but is that an upgrade from a standard c-frame? that's a hell of a deal!
-
captain_john
- Sparky
- Posts: 5880
- Joined: Sun Oct 31, 2004 9:17 am
- Location: KPYM
Post
by captain_john »
OIC...
I still want an upgrade!
CJ
RV-7
Garmin G3X with VP-X & a TMX-IO-360 with G3i
It's all over but the flying! 800+ hours in only 3 years!