Sherwin Williams Coatings

captain_john · Post by **captain_john** » Sun Nov 27, 2005 9:36 pm

Has anyone used these products?

http://www.sherwin-automotive.com/refer ... =Dimension

I am thinking of doing some experimentation. I made a bumper for my JEEP about a year ago. All it really needs is a few more welds, prep and paint.

I am thinking of media blasting and priming with my DuPont VariPrime and topcoating with:

http://www.sherwin-automotive.com/media ... h/6034.pdf

DIMENSION HS Urethane Enamel 3.5 VOC, like it seems Dan did on his interior.

I expect that the JEEP bumper experiment is the most extreme in durability testing.

Anyone with any experience here that can add to this conversation?

CJ

Post by **Spike** » Wed Nov 30, 2005 3:32 pm

Dont know if you noticed or not CJ but someone posted in the Vendor Forum about a good source for Sherwin products. He may have an opinion for you.

-- John

captain_john · Post by **captain_john** » Wed Nov 30, 2005 4:40 pm

I did see that! The product cited was not the DIMENSION HS Urethane Enamel 3.5 VOC, but good information none the less!

I need to go back there and review the thread. I had plans of visiting the SW store here this week and talk to the representative, but haven't had a chance to get there yet.

More to come, I am sure!

CJ