Page 1 of 1
Need DWG EET-1
Posted: Sat Jul 29, 2006 7:31 pm
by svanarts
I can't for the life of me find EET-1 for installing electric trim. There aren't any geeks out there that might have a PDF of it... are there?
Otherwise I'll put in a call to Van's. Thanks!
Posted: Sat Jul 29, 2006 7:46 pm
by captain_john
Hmmmmm, I was s'posta have a plan for that?
I dunno... I just did what felt right?!? I looked at some planes and did it up.
You don't need no stinkin' plans!!!
CJ
Posted: Sat Jul 29, 2006 8:10 pm
by svanarts
Posted: Sat Jul 29, 2006 8:26 pm
by captain_john
You already built one plane!!! You can pull this one off!
CJ
Posted: Sat Jul 29, 2006 9:10 pm
by JohnR
I don't think I had an EET-1. There was a diagram on DWG 4 showing some detail, but that is all I remember except for the wiring diagrams that came with the trim unit.
That was a lot of help wasn't it.
Posted: Sat Jul 29, 2006 11:10 pm
by svanarts
captain_john wrote:You already built one plane!!! You can pull this one off!
CJ
But...
but...
but...
Alright, get it together man I'm a rivet-:bang: 'r
I can do this. Just need to think.
Posted: Sun Jul 30, 2006 12:20 am
by svanarts
JohnR wrote:I don't think I had an EET-1. There was a diagram on DWG 4 showing some detail, but that is all I remember except for the wiring diagrams that came with the trim unit.
That was a lot of help wasn't it.
Actually, yes it was!
I just ordered the parts from my RV-7 drawings, #4 as JohnR pointed out. I'll adapt those to my -4. Prepunched and everything!
Dude, you're a genious!
Posted: Sun Jul 30, 2006 5:15 pm
by JohnR
Glad to be of help.
but...