Page 1 of 1
Spar Spacer Bars
Posted: Tue Aug 04, 2009 8:48 pm
by Spike
Anyone have spar spacer bars they are done with and won't mind loaning out?
Spike
Spar Spacer Bars
Posted: Tue Aug 04, 2009 9:01 pm
by cjensen
Send me your addy Spike...I just got mine back from Brad on the west coast, so now I'll send em to the other side!
Sent from Chad's iPhone
On Aug 4, 2009, at 8:48 PM, RB Lists - The Hangar <
support@rivetbangers.com (
support@rivetbangers.com)> wrote:
Submitted via email
Posted: Wed Aug 05, 2009 7:15 am
by Spike
Woo Hoo! You guys are the bomb. Addy on its way via PM.
Dad is over here for this we and we are tag teaming the fuse full time. We are kicking butt! In two days just about all of the rear bulkheads are fabbed and I'm almost done with the spar carry through. Firewall parts are all ready for priming, WooHooo....
Spike
Posted: Wed Aug 05, 2009 7:54 pm
by BSwayze
Spike,
I would recommend considering the advice of Mike Bullock and myself in regard to painting the firewall stiffeners with your final interior topcoat BEFORE riveting them to the firewall. It's a pain, and time consuming to mask it off later on after it's done. Much easier to paint those parts now, and then rivet it together. It's never too early to choose an interior color and start painting. Here's a link to Mike's entry:
http://rvplane.com/?categoryid=4&dayid=449
Here's my masking and taping work before I was able to topcoat them. I wish I had painted them first:
Here's the finished job. Turned out okay, but took a lot more time:
Posted: Thu Aug 06, 2009 7:02 am
by Spike
Thats exactly what I had in mind. I am currently stockpiling parts right now to hold a huge primer party
