?????

Tom Harp · Post by **Tom Harp** » Thu Aug 26, 2010 7:00 pm

Hi again Scott
Below(Ihope) is a oic, and I was wondering about the large 1"x1" angle that attaches to the firewall & the bulkhead in the pic. It looks like it maybe should attach (at the bulkhead as in the pic so that the skin on top of it would be flush all across it, but the plans show it as in pic #. Youn remember -what you did here?
Thanks
Tom

"[img]"vC:\Documents%20and%20Settings\Tom%20Harp\My%20Docum[img][/img]

svanarts · Post by **svanarts** » Thu Aug 26, 2010 7:03 pm

Sorry Tom, your picture didn't come through. You need to upload it first.

svanarts · Post by **svanarts** » Thu Aug 26, 2010 7:55 pm

I'm pretty sure I attached it per drawing. However, the guiding principle on these things is make sure you build it from the center out, and from the outside in. Meaning, make sure that it is built such that the skins on the outside all fit together flush and nice. Maybe when you get your other pictures to upload I can be more helpful.