Hi all -
I'm not sure if this is my screw-up or Van's - but thought I'd share it.
I laid out the holes & dimensions on the T-915 anti-rotation angle (the one that goes inside the fuel tank).
After checking it a couple of times I drilled the holes in both angles.
But when dry-fitting the parts, the angle stood ~ .030 off the cover plate.
I ended up making a small shim under each bracket.
No big deal.. but an extra step.... and I'm going to have to be carefull when sealing.
Live & learn...
Lorin D
9A Wings
(N194LD reserved)
anti-rotation bracket oops??
- Lorin Dueck
- Class D
- Posts: 252
- Joined: Sun Dec 25, 2005 2:12 pm
- Location: San Jose, CA
- Contact:
- Wicked Stick
- Class B
- Posts: 1000
- Joined: Wed Feb 09, 2005 10:00 pm
- Location: KEWB
- Lorin Dueck
- Class D
- Posts: 252
- Joined: Sun Dec 25, 2005 2:12 pm
- Location: San Jose, CA
- Contact:
Thanks WS -
I thought about enlarging the holes - but decided against it.
Why??
I'm not sure... but it's probably my compulsive engineering geek side coming out.
No worries... but - I'm now up to my eyeballs in pro-seal (with only one major "oh-crud" so far).
Stay tuned... I'll post as soon as I get pics....
Lorin D
9A Wings (tanks)
N194LD reserved
I thought about enlarging the holes - but decided against it.
Why??
I'm not sure... but it's probably my compulsive engineering geek side coming out.
No worries... but - I'm now up to my eyeballs in pro-seal (with only one major "oh-crud" so far).
Stay tuned... I'll post as soon as I get pics....
Lorin D
9A Wings (tanks)
N194LD reserved
Can't wait for your pics Lorin! I'm in the final stretch on my tanks...should be finished over the coming weekend (I hope!!).Lorin Dueck wrote:...
No worries... but - I'm now up to my eyeballs in pro-seal (with only one major "oh-crud" so far).
Stay tuned... I'll post as soon as I get pics....
Lorin D
9A Wings (tanks)
N194LD reserved