Wiring for tail light ?

[Mark Browning]

Hi Guy’s

Has anyone got any idea on how /where to pass the wiring harness through the vertical stab, for the rear tail light on the rudder?
Scratching my head with this one!

[cjensen]

I don't have an exact answer for you, but if you have the issues of the RVator from this year (maybe '05??), there was a nice write up on how and where to do it.

[Dan A]

Mark,
I ran mine thru the vertical stab just above the center hinge point where I drilled a 1/2 in hole for the wire, and then ran the wire down the rudder thru a slot I cut in the rudder L.E. and down to the lower faring then back to the tail light in the faring. I protected the wire with some linear gromet material i bought from ACS. It works great and does not bind the rudder and provides plenty of length for flexing. Good Luck,

Dan

[Mark Browning]

Hi Dan

Thanks for the advice, sounds a good way to me

[RVNewsletter]

RVAtor had an article on this awhile back. IN fact, I stuck some pix in the very firstRV Builder's Hotline. and I stuck a pdf of the article in the Yahoogroup file section.

[Mark Browning]

RVAtor had an article on this awhile back. IN fact, I stuck some pix in the very firstRV Builder's Hotline. and I stuck a pdf of the article in the Yahoogroup file section.

Thanks for the info and link

Cheers

[Mark Browning]

Mark,
I ran mine thru the vertical stab just above the center hinge point where I drilled a 1/2 in hole for the wire, and then ran the wire down the rudder thru a slot I cut in the rudder L.E. and down to the lower faring then back to the tail light in the faring. I protected the wire with some linear gromet material i bought from ACS. It works great and does not bind the rudder and provides plenty of length for flexing. Good Luck,

Dan

Hi Dan

I like the your idea
many thanks
Mark