Congratulations on reaching the home stretch! Looks like fun. Its amazing how much time that little amount of parts takes. Have you worn one of the wheel pants like a "CONEHEAD" yet? On a serious note, I would cover that engine mount with gun oil or grease to keep it from rusting. Its easier to prevent the rust than it would be to remove it.
cjensen wrote:
From the time the truck pulled up, to me finishing the inventory, was 3 hours flat.
3 hours including inventorying every bolt, washer nut and cotter pin in the hardware bags too? If so, my hats off to you. The hw alone bag took me 3 hours!
Anyways, congratulations dude! So far the finish kit has been fun to work on...well except for the canopy frame, but you will discover that fun in a few weeks!
PS - You get any word on the backordered Sam James cowls? I am thinking about writing Liz tomorrow to see how much longer the wait is.
Mike Bullock http://www.rvplane.com RV-7 | Superior IO-360 | Whirlwind 200RV Garmin GTN650 | GRT Dual Sport SX EFIS
Status: FLYING!
bullojm1 wrote:3 hours including inventorying every bolt, washer nut and cotter pin in the hardware bags too? If so, my hats off to you. The hw alone bag took me 3 hours!
I should *asterisk* the 3 hours because I don't count every nut and bolt. I check to make sure I have the correct bag, and move on. I haven't missed anything yet...and if I am missing something, it's nothing a quick trip downstairs to the parts department won't take care of.
bullojm1 wrote:PS - You get any word on the backordered Sam James cowls? I am thinking about writing Liz tomorrow to see how much longer the wait is.
I went to the bottom of the list since I had to get questions answered about whether or not the cowl would work with the 320, so I'm WAY out if the current ones are still back ordered. I should probably check to make sure I'm still on the list...
