LED Position Light Update?

Rockyjs · Post by **Rockyjs** » Wed Dec 19, 2007 7:10 pm

Brantel, or anyone else
Can you give any update on your LED project? Pics? I'm at the crossroad at whether to roll my own LED or just stick some Nav lights in until I can revisit at a later time.

Thanks

Brantel · Post by **Brantel** » Thu Dec 20, 2007 9:18 am

No additional pics from me but mine look just like Chads:

http://www.chadandbrittne.com/November% ... 013-06.htm

Just make sure you order Cyan Led's instead of green.

I used K2 Stars on both red and green originally so I was able to mount my stars using 4-40 screws.

I am changing to cyan stars and they are not available in the K2 series so I am now having to go to the Luxeon III star which is required to be issolated. Therefore I have to glue them to the baseplate with thermal epoxy.

Here is some pics of my assembly:

tmbg · Post by **tmbg** » Thu Dec 20, 2007 10:15 am

wait, Cyan why?

Post by **bullojm1** » Thu Dec 20, 2007 10:22 am

Ian-

The color the Cyan LED's produce is within the tolerances of "aviation green". The green LED's don't fall into those tolerances. There was a decent discussion of this on the other forum:

http://www.vansairforce.com/community/s ... yan&page=2

Brantel · Post by **Brantel** » Thu Dec 20, 2007 1:17 pm

bullojm1 wrote:Ian-

The color the Cyan LED's produce is within the tolerances of "aviation green". The green LED's don't fall into those tolerances. There was a decent discussion of this on the other forum:

http://www.vansairforce.com/community/s ... yan&page=2

Yep that thread on the other forum has tons of info about LED's, Nav light requirements etc. Good thread for info! Lots of charts and graphics showing visuals of the requirements.

They do fall within the tolerance but just inside the tolerance. I suggest cyan because they fall right in the middle of the tolerance. Legally one could argue that the green ones are OK but since there is a better match out there, use it.

I went with green originally because #1: I did not understand the color tolerances. #2 You cannot get a K2 Star in Cyan and I wanted K2's all around. Since the cost is not that great, I decided to switch out my greens for cyan Luxeon III's and all will be good and I won't ever have to argue with anyone about if they meet the spec or not.

Rockyjs · Post by **Rockyjs** » Fri Dec 21, 2007 4:46 pm

Thanks for the update Brantel. They look very bright. Nice work!!

tmbg · Post by **tmbg** » Fri Dec 21, 2007 6:05 pm

out of curiosity... are the LED green traffic lights actually cyan? I got to looking at them the last few days and I think they might be!

Tim d · Post by **Tim d** » Fri Dec 21, 2007 7:30 pm

I'am using kuntzleman combo LED nav,strobe &aft white. Clean & small
setup for $388. Very happy with them.

Tim d · Post by **Tim d** » Fri Dec 21, 2007 7:33 pm

Brantel your setup is looking real nice.