an 515 8R8 screw

A forum in which to discuss topics that are not specific to a particular series of aircraft (ie. how to cut alclad)
Post Reply
User avatar
Joe Parish
Class D
Posts: 311
Joined: Wed Apr 21, 2010 3:42 pm
Location: Sioux Falls SD

an 515 8R8 screw

Post by Joe Parish »

Working on the inboard ribs for the tanks and was not sure what size hole to drill for AN515 8R8 screw which goes into a k1000 platenut? I believe it to be a #19 drill bit but not for sure. Looking for advice. Thanks!
Joe
N525XC reserved
Empennage done
wings done
Fuse in progress
RV-9A

User avatar
cjensen
Whiskey Victor
Posts: 5275
Joined: Sat Apr 23, 2005 10:36 pm
Location: Green Bay, WI

Post by cjensen »

That's correct Joe, #19 hole for a #8 screw.
Chad Jensen
Missing my RV-7...
Vertical Power support
920.216.3699
http://verticalpower.com

User avatar
Joe Parish
Class D
Posts: 311
Joined: Wed Apr 21, 2010 3:42 pm
Location: Sioux Falls SD

AN515 8R8 screw

Post by Joe Parish »

Thanks Chad! That's what I thought but was not sure.
Joe
N525XC reserved
Empennage done
wings done
Fuse in progress
RV-9A

Post Reply