Aileron Push Pull Tube Lengths ?

Mike Balzer · Post by **Mike Balzer** » Sun May 27, 2012 10:14 am

I am about to build the large and small Aileron push pull tubes. Before I cut them just want to know if they should be cut 1/8 or 1/4 longer.

I just want to check with other builders to see if VANS indicated length is good to go or if builders wished they would have gone a little longer.

Thank you.
Mike Balzer

captain_john · Post by **captain_john** » Sun May 27, 2012 12:31 pm

Mike,

Just rigged mine up and everything was just fine. The standard length works out just fine. Build it to the plans, MAN!

Remember, it isn't all about length.

I have never had any complaints!

CJ

painless · Post by **painless** » Sun May 27, 2012 1:58 pm

captain_john wrote:
Remember, it isn't all about length.

I have never had any complaints!

CJ

Mike Balzer · Post by **Mike Balzer** » Sun May 27, 2012 2:42 pm

Thanks for the reply
I will cut mine to exact size.

Mike