Chad:
You may save $35.00, but its gonna cost you a beer, and not some fruity one.....at the Otter!
I followed the instructions I found in an RVator article. If you can get ahold of one of the ****years of the RVator book, it should be in there. I can make you a copy and bring it to the Otter.
It is really not hard at all. I think it is easier to do than messing with fiberglass.
This is the template you make. You mark it every 3 inches or so and then record what the angle is between the windshield and the fuse skin. That will determine what angle the flange will be bent at each of these locations.
This is a bending brake you make. The .025 sheet is clamped between these two pieces of wood so you can bend the flange on the fairing.
[/img]
This is a closeup of one side of the fairing clecoed in place
If you want more info outta me, its gonna cost you another beer......
Plenty of boats to choose from up here. Seems like everyone is selling them along with their campers. There's what you need Chad! A camper!
If you need more info to get going on it this weekend, give me a call 715-582-3059 or 715-923-2613 (cell)
