a couple printed widgets

[A2022]

wrapping this one up. a rugged between the legs folding cup holder for the spar forward cover. it can support a 32 lb coffee cup and bounce right back if screw mounted. if 3M Dual Lock mounted it will support a 24 lb coffee cup before the dual lock fails. you can even kick it. when you have fat old guys climbing in small planes, it needs to be rugged around the feet. very nice but will be expensive for a cup holder. what's the point in doing something well if it is too expensive for most people? well, I'll tell you, it is the simple fact that it can be done. perhaps someone in the future will make one that is less expensive. moving on to something else....












**********

Amazon has these for $4.99
https://www.amazon.com/DUMEALAGR-Adjust ... 7818&psc=1

[A2022]

a rugged between the legs folding cup holder for the spar forward cover. installed to pilot side for comprehensive testing.

da action movie...
https://video.wixstatic.com/video/8fb5f ... 4/file.mp4



***************

photos

[A2022]

folding cup holder .... testing. the cup holder was folded when I boarded the aircraft, and I did not notice it and had even forgotten about it. so boarding is not a factor for me with the cup holder folded. the white bottle is taller, and I noticed it slightly on the bottom of my right leg but it was not a factor. I did not notice the green water bottle at my leg because it is slightly shorter. both bottles and the cup were within easy reach. folding and unfolding is easily done when flying. upon aircraft departure I forgot to fold it and bumped it with the heel of my shoe. that was not a problem because it was designed for that event, it is very rugged. overall, I was very happy with it.

another goal was to soften three weeks of bugs and put the aircraft down for condition inspection. 105 hours on this oil but I found some "stuff" in the oil suction screen. I will cut the filter tomorrow after it drains.

[A2022]

a toggle switch lever for the speed brake... Cessna 210

[A2022]

what's up with all these red tow bar brackets?

[A2022]

these parts have been installed for 7 years. white ABS material which is subject to UV rays. I decided to paint the wing tie down fairings white.

[A2022]

Printing another batch of these... The key to successful ASA printing is to print slowly, use a high nozzle temperature, and ensure a heated chamber. I typically make runs of a dozen.

[A2022]

A mini sized single-hole baffle wire seal... I'm checking this out for a request. So far, not too bad.

[A2022]

mini single wire seal.... not too bad. crank up the heat!

[A2022]

GPS Dock, 760, flush to dock face, mount hole configuration "D". hey, get exactly what you want in a dock.

[A2022]

canopy guide drill block. I have been selling a few of these lately.

[A2022]

the last part of a busy printing day.... a shirt hanger mount.

[A2022]

some parts that I made today. a couple printers still running this late afternoon. have a good one.

[A2022]

Oil fill door tube support, interior mount.....

I use this little tube frequently, but the Velcro I rely on to secure it in the cabin is wearing out, so I needed a better storage solution. A simple string might suffice, but I prefer something more secure. I came up with a prototype cabin mount for this little tube—a small thing, but it gets a lot of use.






********************************

the first print seems good enough for testing